W25Q128BV
7.2.5 Write Enable (06h)
The Write Enable instruction (Figure 4) sets the Write Enable Latch (WEL) bit in the Status Register to a
1. The WEL bit must be set prior to every Page Program, Quad Page Program, Sector Erase, Block
Erase, Chip Erase, Write Status Register and Erase/Program Security Registers instruction. The Write
Enable instruction is entered by driving /CS low, shifting the instruction code “06h” into the Data Input (DI)
pin on the rising edge of CLK, and then driving /CS high.
/CS
Mode 3
0
1
2
3
4
5
6
7
Mode 3
CLK
Mode 0
Mode 0
Instruction (06h)
DI
(IO 0 )
DO
High Impedance
(IO 1 )
Figure 4. Write Enable Instruction Sequence Diagram
7.2.6 Write Enable for Volatile Status Register (50h)
The non-volatile Status Register bits described in section 7.1 can also be written to as volatile bits. This
gives more flexibility to change the system configuration and memory protection schemes quickly without
waiting for the typical non-volatile bit write cycles or affecting the endurance of the Status Register non-
volatile bits. To write the volatile values into the Status Register bits, the Write Enable for Volatile Status
Register (50h) instruction must be issued prior to a Write Status Register (01h) instruction. Write Enable
for Volatile Status Register instruction (Figure 5) will not set the Write Enable Latch (WEL) bit, it is only
valid for the Write Status Register instruction to change the volatile Status Register bit values.
/CS
Mode 3
0
1
2
3
4
5
6
7
Mode 3
CLK
Mode 0
Mode 0
Instruction (50h)
DI
(IO 0 )
DO
High Impedance
(IO 1 )
Figure 5. Write Enable for Volatile Status Register Instruction Sequence Diagram
- 22 -
相关PDF资料
W25Q16BVSFIG IC SPI FLASH 16MBIT 16SOIC
W25Q16CVSFIG IC SPI FLASH 16MBIT 16SOIC
W25Q16DWSFIG IC FLASH SPI 16MBIT 16SOIC
W25Q16VSFIG IC FLASH 16MBIT 80MHZ 16SOIC
W25Q32BVZPIG IC SPI FLASH 32MBIT 8WSON
W25Q32DWZEIG IC FLASH SPI 32MBIT 8WSON
W25Q40BWSSIG IC FLASH SPI 4MBIT 8SOIC
W25Q40BWZPIG IC FLASH SPI 4MBIT 8WSON
相关代理商/技术参数
W25Q128BVEIG TR 制造商:Winbond Electronics Corp 功能描述:SPIFLASH, 128M-BIT, 4KB UNIFOR
W25Q128BVEIP 制造商:WINBOND 制造商全称:Winbond 功能描述:3V 128M-BIT SERIAL FLASH MEMORY WITH DUAL AND QUAD SPI
W25Q128BVFIG 制造商:Winbond Electronics Corp 功能描述:Flash Serial-SPI 3.3V 128Mbit 16M x 8bit 8.5ns 16-Pin SOIC 制造商:Winbond Electronics Corp 功能描述:128MB SPI FLASH
W25Q128BVFIP 制造商:WINBOND 制造商全称:Winbond 功能描述:3V 128M-BIT SERIAL FLASH MEMORY WITH DUAL AND QUAD SPI
W25Q128FV 制造商:WINBOND 制造商全称:Winbond 功能描述:SERIAL FLASH MEMORY WITH DUAL/QUAD SPI & QPI
W25Q128FVAIG 制造商:WINBOND 制造商全称:Winbond 功能描述:3V 128M-BIT SERIAL FLASH MEMORY WITH DUAL/QUAD SPI & QPI
W25Q128FVAIP 制造商:WINBOND 制造商全称:Winbond 功能描述:3V 128M-BIT SERIAL FLASH MEMORY WITH DUAL/QUAD SPI & QPI
W25Q128FVAIQ 制造商:WINBOND 制造商全称:Winbond 功能描述:3V 128M-BIT SERIAL FLASH MEMORY WITH DUAL/QUAD SPI & QPI